Categories

ATmega8A - 8-bit Microcontroller with 8K Bytes Flash PDIP-28

ATmega8A - 8-bit Microcontroller with 8K Bytes Flash PDIP-28
Product Code: TD-AT8L
Availability: In Stock
Price: Rs. 129.00
Qty:     - OR -   Add to Wish List
Add to Compare

 

ATmega8A - 8-bit Microcontroller with 8K Bytes Flash - 28Pin

The high-performance, low-power Atmel 8-bit AVR RISC-based microcontroller combines 8KB ISP flash memory with read-while-write capabilities, 512B EEPROM, 1KB SRAM, 23 general purpose I/O lines, 32 general purpose working registers, three flexible timer/counters with compare modes, internal and external interrupts,serial programmable USART, a byte oriented two-wire serial interface, 6-channel 10-bit A/D converter, programmable watchdog timer with internal oscillator, SPI serial port, and five software selectable power saving modes. The device operates between 2.7-5.5 volts.

Features:
  • 28-pin AVR Microcontroller
  • Flash Program Memory: 8 kbytes
  • EEPROM Data Memory: 512 bytes
  • SRAM Data Memory: 1 kbytes
  • I/O Pins: 23
  • Timers: Two 8-bit / One 16-bit
  • A/D Converter: 10-bit Six Channel
  • PWM: Three Channels
  • RTC: Yes with Separate Oscillator
  • MSSP: SPI and I²C Master and Slave Support
  • USART: Yes
  • External Oscillator: up to 8MHz
Specifications:
  • High-performance, Low-power AVR 8-bit Microcontroller
  • Advanced RISC Architecture
    • 130 Powerful Instructions - Most Single Clock Cycle Execution
    • 32 x 8 General Purpose Working Registers
    • Up to 16 MIPS Throughput at 16MHz
    • Fully Static Operation
    • On-chip 2-cycle Multiplier
  • Nonvolatile Program and Data Memories
    • 8k Bytes of In-System Self-Programmable Flash
    • Optional Boot Code Section with Independent Lock Bits
    • 512K Bytes EEPROM
    • Programming Lock for Software Security
    • 1K Byte Internal SRAM
  • Peripheral Features
    • On-chip Analog Comparator
    • Programmable Watchdog Timer with Seperate On-chip Oscillator
    • Master/Slave SPI Serial Interface
    • Two 8-bit Timer/Counters with Separate Prescalar, Compare 
    • One 16-bit TImer/Counter with Seperate Prescaler, Compare and Capture mode
    • Real TIme Counter with Seperate Oscillator
    • Four PWM Channels
    • 8-channel, 10-bit ADC
    • Byte-oriented Two-wire Serial Interface
    • Programmable Serial USART
  • Special Mircocontroller Features
    • Power-on Reset and Programmable Brown-out Detection
    • Internal Calibrated RC Oscillator
    • External and Internal Interrupt Sources
    • Five Sleep Modes: Idle, ADC Noise Reduction, Power-save, Power-down, Standby, and Extended Standby
  • I/O and Packages
    • 23 Programmable I/O Lines
    • 28-pin PDIP, 32-lead TQFP, and 32-pad MLF
  • Operating Voltages
    • 2.7V - 5.5V for ATmega8L
  • Speed Grades
    • 0-16 MHz for ATmega8
  • Power Consumption @ 4 MHz, 3V, and 35°C for ATmega8L
    • Active: 3.6mA
    • Idle Mode: 10mA
    • Power-down Mode: 0.5µA

*Image shown is a representation only.

Write a review

Your Name:


Your Review: Note: HTML is not translated!

Rating: Bad           Good

Enter the code in the box below:



Description

 

ATmega8A - 8-bit Microcontroller with 8K Bytes Flash - 28Pin

The high-performance, low-power Atmel 8-bit AVR RISC-based microcontroller combines 8KB ISP flash memory with read-while-write capabilities, 512B EEPROM, 1KB SRAM, 23 general purpose I/O lines, 32 general purpose working registers, three flexible timer/counters with compare modes, internal and external interrupts,serial programmable USART, a byte oriented two-wire serial interface, 6-channel 10-bit A/D converter, programmable watchdog timer with internal oscillator, SPI serial port, and five software selectable power saving modes. The device operates between 2.7-5.5 volts.

Features:
  • 28-pin AVR Microcontroller
  • Flash Program Memory: 8 kbytes
  • EEPROM Data Memory: 512 bytes
  • SRAM Data Memory: 1 kbytes
  • I/O Pins: 23
  • Timers: Two 8-bit / One 16-bit
  • A/D Converter: 10-bit Six Channel
  • PWM: Three Channels
  • RTC: Yes with Separate Oscillator
  • MSSP: SPI and I²C Master and Slave Support
  • USART: Yes
  • External Oscillator: up to 8MHz
Specifications:
  • High-performance, Low-power AVR 8-bit Microcontroller
  • Advanced RISC Architecture
    • 130 Powerful Instructions - Most Single Clock Cycle Execution
    • 32 x 8 General Purpose Working Registers
    • Up to 16 MIPS Throughput at 16MHz
    • Fully Static Operation
    • On-chip 2-cycle Multiplier
  • Nonvolatile Program and Data Memories
    • 8k Bytes of In-System Self-Programmable Flash
    • Optional Boot Code Section with Independent Lock Bits
    • 512K Bytes EEPROM
    • Programming Lock for Software Security
    • 1K Byte Internal SRAM
  • Peripheral Features
    • On-chip Analog Comparator
    • Programmable Watchdog Timer with Seperate On-chip Oscillator
    • Master/Slave SPI Serial Interface
    • Two 8-bit Timer/Counters with Separate Prescalar, Compare 
    • One 16-bit TImer/Counter with Seperate Prescaler, Compare and Capture mode
    • Real TIme Counter with Seperate Oscillator
    • Four PWM Channels
    • 8-channel, 10-bit ADC
    • Byte-oriented Two-wire Serial Interface
    • Programmable Serial USART
  • Special Mircocontroller Features
    • Power-on Reset and Programmable Brown-out Detection
    • Internal Calibrated RC Oscillator
    • External and Internal Interrupt Sources
    • Five Sleep Modes: Idle, ADC Noise Reduction, Power-save, Power-down, Standby, and Extended Standby
  • I/O and Packages
    • 23 Programmable I/O Lines
    • 28-pin PDIP, 32-lead TQFP, and 32-pad MLF
  • Operating Voltages
    • 2.7V - 5.5V for ATmega8L
  • Speed Grades
    • 0-16 MHz for ATmega8
  • Power Consumption @ 4 MHz, 3V, and 35°C for ATmega8L
    • Active: 3.6mA
    • Idle Mode: 10mA
    • Power-down Mode: 0.5µA

*Image shown is a representation only.

Write a review

Your Name:


Your Review: Note: HTML is not translated!

Rating: Bad           Good

Enter the code in the box below:



Copyright © 2014-2018 TechDelivers.com. All Rights Reserved.