This is 1 Channel 5V Relay Board Module For Arduino PIC AVR DSP ARM. A wide range of microcontrollers such as Arduino, AVR, PIC, ARM and so on can control it.Each one needs 15mA - 20mA driver current and Equipped with high current relay: DC 5V / 10A, AC 250V / 10AStandard interface that can be compa..
This single channel Relay Module operates at 5V TTL signal and is perfect for common Arduino/Raspberry Pi control applications. This board has one (1) on-board relay which can switch up to 10Amps. Relays terminals (C, NC, NO) are accessible through screw terminals which makes wiring up the board ver..
Electrolytic capacitors for usage in electrial and electronic circuits
If your requirement doesn't meet voltage stated above, still you can use this capacitor.
Example- Suppose you need 16volt capacitor than you may also use 25volt capacitor, in most of the cases.(not applicable in case of..
This is the switched-mode power supply
(SMPS) which converts 100-264V AC to 5V DC. It can provide up to 40A
maximum current. All types of protections such as over-voltage
protection, over-current protection, short circuit protection and
surge-protected output are provided in the supply. These SM..
Electrolytic capacitors for usage in electrial and electronic circuits
If your requirement doesn't meet voltage stated above, still you can use this capacitor.
Example- Suppose you need 16volt capacitor than you may also use 25volt capacitor, in most of the cases.x
Specifications
Radia..
Electrolytic capacitors for usage in electrial and electronic circuits
If your requirement doesn't meet voltage stated above, still you can use this capacitor.
Example- Suppose you need 16volt capacitor than you may also use 25volt capacitor, in most of the cases.x
REMEMBER: If circuit op..
It is a 4 Channel Isolated 5V 10A Relay Module, A wide range of
microcontrollers such as Arduino, AVR, PIC, ARM and so on can control
it. It is also able to control various appliances and other types of
equipment with a large current.Relay output maximum
contact is AC250V 10A and DC30V ..
Relay SPDT 5V PCB mount
Features:
Current Contacts
7A 250VAC10A 125VAC10A 30VAC
Easy to use mounts on PCB
Compact Size
Economically Priced
*Image shown is a representation only, color may vary depending on stock. ..
5v-1A Adapter with LED - AC to DC
SMPS Suppy:
Light Weight
Long Life
Safe & Fast
Specifications:
AC input voltage: 100V - 240V, 50Hz / 60Hz
Output DC Voltage: 5V
Output Current: 1A Dual Pin
5.5 mm OD, 2.1mm ID Power Male Plug Connector
3.4 mm OD, 1.3 mm ..
Zener Diode 5.6 Volt, 500mW
Features
Zener Voltage Vz Typ: 5.6 V
Power Dissipation Pd: 500mW
Operating Temperature Min: -65°C
Operating Temperature Max: 200°C
No. of Pins: 2
Breakdown Voltage: 5.6 V
Diode Type: Zener
*Image shown is a representation only...
Relay board module is used for controlling higher current loads from your microcontroller development board, PC parallel port or Arduino Uno. This board has eight (8) on-board 5volt relay which can switch up to 7Amps. Relays terminals (C, NC, NO) are accessible through screw terminals which makes wi..
The Nano Board R3 with CH340 chip without USB Cable chipboard is based on the famous Arduino platform and does all the functions of Uno, but with a smaller footprint.The Nano Board R3 with CH340 chip without USB Cable is vital for your small project where you don’t need much of a pin-outs but the sm..