BO Gear Motor 100RPM Dual Shaft

BO motor range is specifically designed for small battery operated robots. Low in cost, light in weight, small & with low voltage requirement. With a built-in clutch and built-in mounting screw holes. These fit perfectly with BO plastic wheels.

This gear motor is perfect for your next robotics project. This gear motor is ideal for robotic car or line-tracing robot. With plastic construction and colored in bright yellow, the DC gear motor measures approx. 2.5 inch long, 0.85 inch wide and 0.7 inch thick. The wheel can be mounted on either side and the Gear motor works well between 4V to 7V (recommended 6 Volts). At a ratio of 1:48 you can get some really good torque at 5 Volts.

Specification:

•     Dimension: ~ 7x2.2x1.8 cm
•     Shaft length: ~7mm (double flat)
•     RPM - 100
•     Output Torque - 0.8-5kgcm
•     Operating Voltage: 3V~12VDC (recommended operating voltage of about 6 to 8V)
  

*Image shown is a representation only.