nrf24L01 +2.4GHz Antenna Wireless Transceiver Module for Arduino 8051 ARM

Maximum operating speeds up to 2Mbps, GFSK modulation efficiency, Anti-interference ability, particularly suitable for industrial control applications 125 Channels, Multi-point communication and frequency hopping to meet the communication needs. Available software to set the address, only received local Address when output data(Provide interrupt instruction), can be directly connected to a variety of microcontrollers, Software programming is very convenient. 

Built-in hardware CRC error detection, Multipoint communication address control Standard DIP Pitch Interface for embedded applications. 

Features:

• MuitiCwiver hardware provides the function of six receivers
• Link layer within makes the software design more simple
• 2Mbit/s makes it possible for the high quality VoIP

• 2Mbit/s 1Mbit/s 250Kbit/s three optional transmission rate
• Few peripheral components make it possible for low cost
• +/- 60 ppm crystals
• Need external inductance only in antenna matching place
• No need for multi layer PCB
• 5V level input
• No need for external level translator
• Improved ShockBurst and UART are easy to connect with all kinds of low cost
• MCU needs no external level
• Peak current received at; 2Mbit/s is 12.5mA
• Peak current of @0dBm output at; 2Mbit/s is 11mA 2Mbit/s needs small average current; Power consumption is 400mA in power down mode
• Power consumption is 32uA in idle mode
• Quick switch and wake-up time:130us
• Voltage regulator within - Can work in low voltage between 1.9V to 3.6V
• Reduce noise to its best.
• Built-in 2.4GHz antenna

Package Content:

• 1 x Wireless Transceiver Module For Microcontroller

Interface with Arduino: http://playground.arduino.cc/InterfacingWithHardware/Nrf24L01

Opensource Tutorial

*Image shown is a representation only.